- 您現在的位置：買賣IC網 > Datasheet目錄1 > 33-1/G4C-ARTB (Everlight Electronics Co Ltd)LED PWR 3MM INGAN BRILL GRN CLR Datasheet資料下載
參數資料
| 型號： | 33-1/G4C-ARTB |
| 廠商： | Everlight Electronics Co Ltd |
| 文件頁數： | 8/10頁 |
| 文件大?。?/td> | 326K |
| 描述： | LED PWR 3MM INGAN BRILL GRN CLR |
| 標準包裝： | 60 |
| 顏色： | 綠 |
| 正向電壓： | 3.5V |
| 電流 - 測試： | 30mA |
| 波長 - 主： | 525nm |
| 波長 - 峰值： | 518nm |
| 視角： | 90° |
| 透鏡類型： | 透明 |
| 透鏡樣式/尺寸： | 圓形，帶圓頂，3mm |
| 封裝/外殼： | 4-DIP（0.200"，5.08mm） |
| 高度： | 3.85mm |
| 安裝類型： | 通孔 |
| 包裝： | 管件 |
Technical Data Sheet
3mm POWER LED
33-01/G4C-ARTB
Everlight Electronics Co., Ltd. http:\\www.everlight.com Rev.1 Page: 8 of 10
Device number: DPE-0000057 Established date: 05-30-2008 Established by: Jim Lin
particularly when soldering.
Dip and hand soldering should not be done more than one time
After soldering the LEDs, the epoxy bulb should be protected from mechanical shock or
vibration until the LEDs return to room temperature.
A rapid-rate process is not recommended for cooling the LEDs down from the peak
temperature.
Although the recommended soldering conditions are specified in the above table, dip or
handsoldering at the lowest possible temperature is desirable for the LEDs.
Wave soldering parameter must be set and maintain according to recommended
temperature and dwell time in the solder wave.
4. Cleaning
When necessary, cleaning should occur only with isopropyl alcohol at room temperature for
a duration of no more than one minute. Dry at room temperature before use.
Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of
ultrasonic cleaning on the LEDs depends on factors such as ultrasonic power and the
assembled condition. Ultrasonic cleaning shall be pre-qualified to ensure this will not cause
damage to the LED
5. Circuit Protection
Below the zener reference voltage Vz, all the current flows through LED and as the voltage
rises to Vz, the zener diode breakdown." If the voltage tries to rise above Vz current flows
through the zener branch to keep the voltage at exactly Vz.
When the LED is connected using serial circuit, if either piece of LED is no light up but
current cant flow through causing others to light down. In new design, the LED is parallel
with zener diode. if either piece of LED is no light up but current can flow through causing
others to light up.
相關PDF資料 |
PDF描述 |
|---|---|
| 333-2SUGC/H3/S400-A5 | LED 5MM SUP GREEN WATER CLR RND |
| 333-2SURC/S400-A8 | LED 5MM HYPER RED WATER CLR RND |
| 333-2SYGT/S530-E2 | LED 5MM BRILL YLW-GRN GRN TRANSF |
| 333-2UYC/S530-A3 | LED 5MM SUPER YELLOW CLEAR RND |
| 333-2UYD/S530-A3 | LED 5MM SUPER YELLOW DIFF RND |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 331GHR102K | 制造商:Illinois Capacitor Inc 功能描述:GHR Series 6 mm 330 pF 1000 V 10 % Y5P Ceramic Disc Capacitor 制造商:Illinois Capacitor Inc 功能描述:330PF 1,000WV +-10% *NO Pb* 制造商:Illinois Capacitor Inc 功能描述:GHR Series ? 6 mm 330 pF 1000 V ?10 % Y5P Ceramic Disc Capacitor |
| 3-3-1J | 功能描述:變壓器音頻和信號 SMD RF WIDEBAND RoHS:否 制造商:Skyworks Solutions, Inc. 頻率范圍:810 MHz to 960 MHz 初級線圈阻抗: 次級線圈阻抗: 絕緣電壓:23 dB 工作溫度范圍:- 40 C to + 85 C 端接類型:SMD/SMT 尺寸:6 mm L x 4.9 mm W x 1.6 mm H 產品:Splitters and Combiners |
| 331KD05JX | 制造商:MCC 制造商全稱:Micro Commercial Components 功能描述:11 to 460 Volts Varistor 0.7 to 29 Joule |
| 331KD05NX | 制造商:MCC 制造商全稱:Micro Commercial Components 功能描述:4 to 460 Volts Varistor 0.20 to 22.5 Joule |
| 331KD07JX | 制造商:MCC 制造商全稱:Micro Commercial Components 功能描述:11 to 510 Volts 1.5 to 60 Joule |
發布緊急采購，3分鐘左右您將得到回復。