- 您現在的位置：買賣IC網 > Datasheet目錄1 > 1003SURD/S530-A3 (Everlight Electronics Co Ltd)LED HYPER RED DIFF 3.68X6.22MM Datasheet資料下載
參數資料
| 型號： | 1003SURD/S530-A3 |
| 廠商： | Everlight Electronics Co Ltd |
| 文件頁數： | 7/8頁 |
| 文件大小： | 356K |
| 描述： | LED HYPER RED DIFF 3.68X6.22MM |
| 標準包裝： | 500 |
| 顏色： | 紅 |
| Millicandela 等級： | 50mcd |
| 正向電壓： | 2V |
| 電流 - 測試： | 20mA |
| 波長 - 主： | 624nm |
| 波長 - 峰值： | 632nm |
| 視角： | 110° |
| 透鏡類型： | 散射，有色 |
| 透鏡樣式/尺寸： | 矩形，帶平頂，5.71mm x 3.17mm |
| 封裝/外殼： | 徑向 |
| 高度： | 7.11mm |
| 安裝類型： | 通孔，直角 |
| 包裝： | 散裝 |
DATASHEET
LAMP
1003SURD/S530-A3
7
Copyright ?2010, Everlight All Rights Reserved. Release Date : Dec.04. 2013. Issue No: DLE-0006310_Rev.2
www.everlight.com
Although the recommended soldering conditions are specified in the above table, dip or hand soldering at the lowest
possible temperature is desirable for the LEDs.
Wave soldering parameter must be set and maintain according to recommended temperature and dwell time in the solder
wave.
4. Cleaning
When necessary, cleaning should occur only with isopropyl alcohol at room temperature for a duration of no more than
one minute. Dry at room temperature before use.
Do not clean the LEDs by the ultrasonic. When it is absolutely necessary, the influence of ultrasonic cleaning on the LEDs
depends on factors such as ultrasonic power and the assembled condition. Ultrasonic cleaning shall be pre-qualified to
ensure this will not cause damage to the LED
5. Heat Management
Heat management of LEDs must be taken into consideration during the design stage of LED application. The current
should be de-rated appropriately by referring to the de-rating curve found in each product specification.
The temperature surrounding the LED in the application should be controlled. Please refer to the data sheet de-rating
curve.
6. ESD (Electrostatic Discharge)
The products are sensitive to static electricity or surge voltage. ESD can damage a die and its reliability.
When handling the products, the following measures against electrostatic discharge are strongly
recommended:
Eliminating the charge
Grounded wrist strap, ESD footwear, clothes, and floors
Grounded workstation equipment and tools
ESD table/shelf mat made of conductive materials
Proper grounding is required for all devices, equipment, and machinery used in product assembly.
Surge protection should be considered when designing of commercial products.
If tools or equipment contain insulating materials such as glass or plastic,
the following measures against electrostatic discharge are strongly recommended:
Dissipating static charge with conductive materials
Preventing charge generation with moisture
Neutralizing the charge with ionizers
7. Directions for use
The LEDs should be operated with forward bias. The driving circuit must be designed so that the LEDs are not subjected
to forward or reverse voltage while it is off. If reverse voltage is continuously applied to the LEDs, it may cause migration
resulting in LED damage.
8. Other
Above specification may be changed without notice. EVERLIGHT will reserve authority on material change for above
specification.
When using this product, please observe the absolute maximum ratings and the instructions for using outlined in these
specification sheets. EVERLIGHT assumes no responsibility for any damage resulting from use of the product which does
not comply
with the absolute maximum ratings and the instructions included in these specification sheets.
These specification sheets include materials protected under copyright of EVERLIGHT corporation. Please dont
相關PDF資料 |
PDF描述 |
|---|---|
| 103SYGD/S530-E2 | LED 2MM SUPER YLW/GRN DIFF TOWER |
| 11-22/R6G6C-A01/2T | LED RED/GREEN WATER CLEAR 1206 |
| 12-23C/R6GHBHC-A01/2C | LED RED/GREEN/BLUE CLEAR RA SMD |
| 1254-10SYGT/S530-E2 | LED 3MM ROUND YLW/GRN DIFF |
| 1383SDRD/S530-A3 | LED 5MM ROUND DEEP RED DIFF |
相關代理商/技術參數 |
參數描述 |
|---|---|
| 1003SYGD/S530-E2 | 功能描述:標準LED-通孔 Rectangular LED RoHS:否 制造商:Vishay Semiconductors 照明顏色:Red 光強度:0.7 mcd 波長/色溫:615 nm 顯示角:45 deg 透鏡顏色/類型:Clear, Non-Diffused 正向電流:70 mA 正向電壓:1.83 V to 3.03 V LED 大小:2 mm 系列: 封裝:Tube |
| 1003UYD/S530-A3 | 功能描述:標準LED-通孔 Rectangular LED RoHS:否 制造商:Vishay Semiconductors 照明顏色:Red 光強度:0.7 mcd 波長/色溫:615 nm 顯示角:45 deg 透鏡顏色/類型:Clear, Non-Diffused 正向電流:70 mA 正向電壓:1.83 V to 3.03 V LED 大小:2 mm 系列: 封裝:Tube |
| 1003UYD/S530-A3/TR1-2(R) | 制造商:Everlight Electronics Co 功能描述: |
| 1003W3PXX99A30X | 功能描述:D-Sub標準連接器 3W3 MALE NOT LOADED 4-40 INSERT RoHS:否 制造商:Omron Electronics 位置/觸點數量:9 排數:2 型式:Female 安裝風格:Through Hole 安裝角:Right 端接類型:Solder 過濾: |
| 1003W3SXX99S90A | 功能描述:D-Sub標準連接器 3W3 F NOT LOADED BLIND MATING RoHS:否 制造商:Omron Electronics 位置/觸點數量:9 排數:2 型式:Female 安裝風格:Through Hole 安裝角:Right 端接類型:Solder 過濾: |
發(fā)布緊急采購，3分鐘左右您將得到回復。